Stihl 064

STIHL 064, 066 70
Top:
Pushing grommet out of crankcase wall
Top:
Front grommet in carburetor box Center:
Rear grommet in carburetor box
Bottom:
Withdrawing generator connecting Bottom:
wire in direction of rear grommet Generator mounting screws Pulling wire retainer out of crankcase
- Use a blunt screwdriver to push the
lateral grommet out of the crankcase
wall (from outside).
- Take the insulating tube and wires out
of the two retainers on the crankcase.
- Use a blunt tool to push the rear
grommet out of the carburetor box in
the direction of the cylinder.
Note: This job is easier if the carburetor is
removed - see 1 1.4.
- Remove the three generator mounting
screws.
Note: The screws are secured with
Loctite and may be difficult to remove.
- Lift the generator away.
- Use pliers to pull the wire retainer out
of the crankcase.
- Pull generator wire 1 out of the rear
grommet, through the insulating tube
and the retainer.
- Pull terminal pin of generator
wire 1 in rear handle out of the
socket.
- Pull generator wire 1 through the
insulating tube and front grommet.
- Use the assembly hook to pull
generator wire 1 through the
carburetor box in the direction of
the rear grommet.