Stihl BR 380 - Replacing the starter rope; Pry the cap (6) out of the grip.; Remove the remaining rope from the rotor and starter grip.; Tie a simple overhand knot in the new rope and then thread it through the top of the grip and the rope bushing (7).

BR 380
English
19
N Pry the cap (6) out of the grip.
N Remove the remaining rope from
the rotor and starter grip.
N Tie a simple overhand knot in the
new rope and then thread it through
the top of the grip and the rope
bushing (7).
N Refit the cap in the grip.
N Thread the rope through the rotor
and secure it with a simple
overhand knot.
N Refit the pawl (5) in the rotor.
N Fit the washer (4) on the starter
post.
N Use a screwdriver or suitable pliers
to fit the spring clip (3) on the starter
post and over the pawl's peg – the
spring clip must point
counterclockwise – as shown in the
illustration. Go to "Tensioning the
rewind spring".
Replacing a broken rewind spring
N Lubricate the new spring with a few
drops of non-resinous oil.
N Remove the rope rotor as described
in "Replacing the starter rope".
N Remove the spring housing and
pieces of spring.
353BA041 KN
7
6
373BA026 KN
353BA034 KN
3
5
4