15FC 100
English / USA
: Tighten wingnut clockwise.
: Standing in the normal working
position, check the depth of cut
again and correct it if necessary.
Edging
: Start the engine.
: Start the cut at half throttle and
continue cutting at full throttle.
: Hold and guide the unit so that the
blade is vertical.
: Cut steadily so that the engine
speed does not decline to any major
extent – do not apply force!
: Cut at a normal walking pace.
: Do not push the blade into the
ground!
: Always walk forwards when cutting,
do not pull the unit towards you.
: Cut at a steady pace to avoid having
to make several passes.
1 = Gunning sight for cutting blade.
241BA003 KN
241BA004 KN
90°
241BA005 KN
1
To Next Page
Loading...
