Stihl FC 100 - 4-MIX Engine; Blade Installation Details; Fuel Specifications; Gasoline and Oil Mix

17FC 100
English / USA
: Press down the trigger interlock (1)
and squeeze the throttle trigger (2)
(full throttle) – this sets the throttle
cable correctly.
: Place the power edger on a
suitable support so that the blade
mounting (1) faces upwards.
: Insert stop pin* or offset
screwdriver* (2) as far as possible in
the bore (3) – push lightly and rotate
it back and forth together with the
thrust washer (4) until the drive shaft
is blocked.
: Fit combination wrench (5) on the
nut (6).
: Loosen and remove the nut
clockwise (left-hand thread).
: Remove the thrust washer.
* see "Guide to Using this Manual"
2
1
002BA161 KN
Fitting the Edger Blade
241BA006 KN
1
6
3
2
4
5
241BA011 KN