Stihl FR 480 C - Handle and Throttle Cable Installation; Mounting Loop Handle without Barrier Bar; Securing the Loop Handle; Fitting the Throttle Cable

FR 480 C
English
17
Mounting the Loop Handle without
Barrier Bar
N Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
N Fit the clamp (6).
N Line up the holes.
N Fit the washers (7) on the screws
(8), and insert the screws in the
holes.
N Screw the square nuts (1) onto the
screws (8) as far as stop.
N Go to "Securing the Loop Handle".
Securing the Loop Handle
N Secure the loop handle (4) about 20
cm (A) forward of the control
handle (9).
N Line up the loop handle.
N Tighten down the screws firmly –
lock the nuts if necessary.
The sleeve (10) must be between the
loop handle and the control handle.
Fitting the Throttle Cable
N Push the throttle cable (1) into the
two cable retainers (2) about 20 cm
(A) from either end of the shaft.
Go to "Adjusting the Throttle Cable".
8
8
1
4
5
7
1
7
6
3
265BA026 KN
4
A
271BA066 KN
9
10
The whole length of the throttle
cable must run parallel to the
flexible shaft. Do not wrap the
throttle cable around the flexible
shaft.
1
A
A
2
1
2
271BA075 KN