Stihl FR 450 - User Manual

5/20/2018
STIHL FS 350 Service manual.pdf - slidepdf.com
http://slidepdf.com/reader/full/stihl-fs-350-service-manualpdf 1/63
STIHL
FR 350, 450

2003-04
STIH)

STIHLFS 120, 200, 300, 350, 400, 450,
STIH)

www.mymowerparts.com Call 606-678-9623 or 606-561-4983
www.mymowerparts.com Stihl

Stihl FR 450 Specifications

General

Brand	Stihl
Model	FR 450
Category	Brush Cutter
Language	English

Summary

Specifications

2.1 Engine

Details STIHL single cylinder two-stroke engine specifications.

2.2 Fuel System

Specifications for the fuel system, carburetor, and air filter.

2.3 Ignition System

Specifications for the electronic magneto ignition system.

Clutch

3.1 Removing and Installing

Procedures for clutch removal and installation.

3.2 Clutch Carrier

Engine

4.5 Cylinder and Piston

Steps for cylinder and piston assembly removal and installation.

4.7 Crankcase

Procedures for crankshaft removal and installation.

Ignition System

5.3 Ignition Module

5.4 Flywheel

Rewind Starter

6.2 Rewind Spring

6.3 Starter Rope;Starter Grip (ElastoStart)

Throttle Control

7.1 Throttle Trigger;Interlock Lever (Bike Handle)

Procedures for bike handle throttle control disassembly and reassembly.

7.3 Throttle Trigger;Interlock Lever (Loop Handle)

Procedures for loop handle throttle trigger removal and installation.

7.4 Slide Control (Loop Handle)

Instructions for loop handle slide control removal and installation.

7.5 Throttle Cable

Steps for throttle cable replacement and adjustment.

Fuel System

8.2 Carburetor

Carburetor removal, installation, testing, and adjustment procedures.

AV SYSTEM

9.1 Repair (FS 120;200)

Procedures for AV system repair on FS 120/200 models.

9.2 Repair (FS 300...450)

Procedures for AV system repair on FS 300-450 models.

9.3 Repair (FR 350;450)

Procedures for AV system repair on FR 350/450 models.

SHAFT

10.1 Bike Handle (FS 120;200)

10.2 Bike Handle (FS 300...450)

10.3 Loop Handle

10.4 Drive Shaft;Flexible Liner

10.5 Flexible Shaft (FR 350;450)

10.6 Drive Tube

CUTTING TOOL DRIVE

11.1 Gearhead

Instructions for gearhead assembly removal and installation.

11.2 Clutch Drum