Stihl FR 480 C - Mowing Head and Metal Attachment Mounting; Mounting Mowing Heads; Removing Mowing Heads

FR 480 C
English
20
N Take the thrust washer (3) off the
shaft (4). Do not remove the thrust
plate (5).
N Go to "Mounting the Mowing Head"
or "Mounting the Metal Cutting
Attachment".
Mounting the Mowing Head
Keep the instruction sheet for the
mowing head in a safe place.
STIHL SuperCut 20-2,
STIHL AutoCut 25-2,
STIHL AutoCut C 25-2,
STIHL AutoCut 30-2,
STIHL TrimCut 31-2,
STIHL FixCut 25-2,
STIHL PolyCut 20-3
N Screw the mowing head
counterclockwise on to the shaft (1)
as far as stop.
N Block the shaft.
N Tighten down the mowing head.
STIHL FixCut 25-2 (early version)
N Place the mowing head on the
thrust plate (2).
N Push the thrust washer (3) over the
shaft (1) so it is seated on the base.
N Block the shaft.
N Use the combination wrench (5) to
screw the mounting nut (4) onto the
output shaft and it tighten down
firmly.
Removing the Mowing Head
N Block the shaft.
Remove the tool used to block the
shaft.
1
002BA081 KN
Collar (see arrows) must engage
the mowing head's mounting hole.
Remove the tool used to block the
shaft.