Original Instruction ManualPrinted on chlorine-free paper
Printing inks contain vegetable oils, paper can be recycled.
© ANDREAS STIHL AG & Co. KG, 2013
0458-258-8621-D. VA5.L13.
0000000683_012_GB
FS 130, FS 130 R
English
1
{
This instruction manual is protected by copyright. All rights reserved, especially the rights to reproduce, translate and process
with electronic systems.
Contents
Allow only persons who fully understand
this manual to operate your trimmer /
brushcutter.
To receive maximum performance and
satisfaction from your STIHL trimmer /
brushcutter, it is important that you read,
understand and follow the safety
precautions and the operating and
maintenance instructions in chapter
"Safety Precautions and Working
Techniques" before using your trimmer /
brushcutter. For further information you
can go to www.stihlusa.com.
Contact your STIHL dealer or the STIHL
distributor for your area if you do not
understand any of the instructions in this
manual.
WARNING
Because a trimmer / brushcutter is a
high-speed cutting tool some special
safety precautions must be observed to
reduce the risk of personal injury.
Careless or improper use may cause
serious or even fatal injury.
Make sure your unit is equipped with the
proper deflector, handle and harness for
the type of cutting attachment being
used. Always wear proper eye
protection.
Guide to Using this Manual 2
Safety Precautions and Working
Techniques 3
Approved Combinations of Cutting
Attachment, Deflector, Handle and
Harness 18
Approved Power Tool Attachments 20
Mounting the Bike Handle 20
Mounting the Loop Handle 22
Adjusting the Throttle Cable 24
Fitting the Carrying Ring 24
Mounting the Deflector 24
Mounting the Cutting Attachment 25
4-MIX Engine 28
Fuel 28
Fueling 29
Fitting the Harness 31
Balancing the Trimmer/Brushcutter 32
Starting / Stopping the Engine 33
Operating Instructions 35
Cleaning the Air Filter 36
Engine Management 36
Adjusting the Carburetor 36
Spark Arresting Screen in Muffler 38
Spark Plug 39
Lubricating the Gearbox 40
Rewind Starter 40
Storing the Machine 41
Sharpening Metal Cutting Blades 41
Maintaining the Mowing Head 42
Maintenance and Care 44
Main Parts 46
Specifications 48
Special Accessories 49
Maintenance and Repairs 49
Disposal 50
STIHL Incorporated Federal
Emission Control Warranty
Statement 50
STIHL Incorporated California
Exhaust and Evaporative
Emissions Control Warranty
Statement 52
Trademarks 54
To Next Page
Loading...
Need help?
General
