Stihl FS 250 R User Manual

FS 250, FS 250 R
English
32
N Carry out standard setting.
N Warm up the engine.
N Turn high speed screw (H) slightly
clockwise (leaner) – no more than a
3/4 turn.
NOTICE
After returning from high altitude, reset
the carburetor to the standard setting.
If the setting is too lean there is a risk of
engine damage due to insufficient
lubrication and overheating.
N If the engine is down on power,
difficult to start or runs poorly at idle
speed, first check the spark plug.
N Fit a new spark plug after about 100
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
Removing the Spark Plug
N Turn off the engine.
N Pull off the spark plug boot (1).
N Unscrew the spark plug.
Checking the Spark Plug
N Clean dirty spark plug.
N Check electrode gap (A) and
readjust if necessary – see
"Specifications".
N Rectify the problems which have
caused fouling of the spark plug.
Possible causes are:
– Too much oil in fuel mix.
– Dirty air filter.
– Unfavorable running conditions.
WARNING
Arcing may occur if the adapter nut (1) is
loose or missing. Working in an easily
combustible or explosive atmosphere
may cause a fire or an explosion. This
can result result in serious injuries or
damage to property.
Spark Plug
250BA054 KN
000BA039 KN
A
1
000BA045 KN

Stihl FS 250 R Specifications

General

Brand	Stihl
Model	FS 250 R
Category	Trimmer
Language	English