FS 250, FS 250 R
English
30
N Swing wire rod outwards.
N Fit transport guard on saw blade
from below, making sure the limit
stop is properly seated in the
recess.
N Swing wire rod into position.
N Hook wire rod to the transport
guard.
During break-in period
A factory-new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Empty the fuel tank
and keep the machine in a dry place,
well away from sources of ignition, until
you need it again. For longer out-of-
service periods – see "Storing the
Machine".
If there is a noticeable loss of engine
power
N Turn the choke knob to g.
N Press in the tab (1) and remove the
filter cover (2).
N Clean away loose dirt from around
the filter (3) and inside the filter
cover.
N Remove and check the filter
element – replace it if is dirty or
damaged.
N Install the filter element in the filter
cover.
N Refit the filter cover.
Operating Instructions Air filter
To Next Page
Loading...
