Why is the starter rope hard to pull on my Stihl Brush Cutter?
If the starter rope is difficult to pull or rewinds very slowly, the starter mechanism may be very dirty. Thoroughly clean the complete starter mechanism.
What causes a Stihl Brush Cutter gearbox to run rough and stop under load?
If the gearbox runs rough and stops running under load, the drive shaft may not fully engage. Push the gearbox onto the drive tube drive pinion assembly until the drive shaft fully engages the drive pinion.
Why is my Stihl Brush Cutter making loud noises?
Loud noises could be caused by stretched tension springs. Replace all tension springs. Alternatively, the ball bearings may be damaged or worn, in which case you should replace the ball bearings on the drive side and non-drive side.
Why is the gearbox on my Stihl Brush Cutter becoming too hot?
If the gearbox becomes too hot, it may be due to excessive friction caused by damaged or worn ball bearings. Replace the ball bearings on the drive side and non-drive side. You may also need to add gear lubricant.
Why does the drive tube assembly on my Stihl Brush Cutter get very warm?
If the drive tube assembly becomes very warm, the drive shaft may not be sufficiently lubricated. Lubricate the drive shaft along its entire length, ensuring the entire length of the flexible liner is lubricated.
Why is my Stihl Brush Cutter drive tube assembly vibrating?
If the drive tube assembly vibrates, the flexible liner may be worn, causing the drive shaft to be insufficiently supported. Replace the flexible liner.
Why doesn't the bike handle clamp on my Stihl Brush Cutter?
If the bike handle does not clamp, the clamps may be greasy or oily. Clean the clamps and bike handle.
Why can't I adjust the bike handle on my Stihl Brush Cutter anymore?
If the bike handle can no longer be adjusted, the clamps may be dirty. Clean the clamps and bike handle.
How to stop the cutting attachment rotating at idle on my Stihl Brush Cutter?
If the cutting attachment rotates at idle, the idle speed may be too high. Readjust the idle speed screw LA. If that doesn't resolve the issue, further diagnosis may be needed.
How to fix faulty tank vent on Stihl Brush Cutter?
Replace the tank vent.
Covers essential warnings, notices, and before-start checks for safe operation.
Guides on mounting cutting attachments, guard rings, and deflectors.
Covers mounting, checking, and cleaning thrust plate and guard washer.
Provides detailed information on fuel types and safe fueling practices.
Covers controls, starting procedures, and stopping the engine.
Outlines general maintenance procedures and recommendations.
To Next Page
General
