To Next Page
W
Wesley MccartySep 2, 2025
What to do if spring is insufficiently tensioned on Stihl Brush Cutter?
- MMichael HardySep 2, 2025
Check rewind spring and increase tension.
What to do if spring is insufficiently tensioned on Stihl Brush Cutter?
Check rewind spring and increase tension.
What to do if throttle shutter does not close on Stihl Brush Cutter?
Replace carburetor.
What to do if screws of the clutch are loose on Stihl Brush Cutter?
Tighten the screws. Replace the clutch if necessary and check the threaded holes on the flywheel, replacing the flywheel if needed.
How to fix broken tension springs of the clutch shoes on Stihl Brush Cutter?
Replace tension springs.
How to fix a broken rewind spring on Stihl Brush Cutter?
Replace rewind spring.
What to do if oil seals or crankcase leaking on Stihl Brush Cutter?
Seal the oil seals or crankcase; replace if necessary.
How to fix worn inlet needle on Stihl Brush Cutter?
Replace inlet needle.
How to clean fuel strainer on Stihl Brush Cutter?
Clean the fuel strainer in the carburetor, and replace it if necessary.
How to fix spring clip fatigued on Stihl Brush Cutter?
Replace spring clip.
How to fix tension springs of the clutch shoes are stretched on Stihl Brush Cutter?
Replace tension springs, replace clutch if necessary.
Covers essential warnings, notices, and before-start checks for safe operation.
Guides on mounting cutting attachments, guard rings, and deflectors.
Covers mounting, checking, and cleaning thrust plate and guard washer.
Provides detailed information on fuel types and safe fueling practices.
Covers controls, starting procedures, and stopping the engine.
Outlines general maintenance procedures and recommendations.
General
