FS 40, FS 40 C, FS 50, FS 50 C
English
24
Controls
Version with loop handle
1 Throttle trigger lockout
2 Throttle trigger
3 Momentary stop switch with Run
and 0 = Stop positions.
Function of momentary stop switch and
ignition system
The momentary stop switch is normally
in the Run position: Ignition is on in this
position – the engine is ready to start
and may be started. If the momentary
stop switch is moved to the 0 position,
the ignition is off. It is automatically
switched on again after the engine
comes to a standstill.
Starting the Engine
N Press the fuel pump bulb (4) at least
five times – even if the bulb is
already filled with fuel.
Cold engine (cold start)
N Press in the choke lever (5) and turn
it to g at the same time.
Warm engine (warm start)
N Press in the choke lever (5) and turn
it to < at the same time.
Also use this setting if the engine has
been running but is still cold.
Starting
N Place the unit on the ground: It must
rest securely on the engine support
and the deflector. Check that the
cutting attachment is not touching
the ground of any other obstacles.
N Make sure you have a firm footing.
N Hold the unit firmly on the ground
with your left hand and press down
– do not touch the throttle trigger or
throttle trigger lockout lever.
Do not stand or kneel on the drive tube.
Starting / Stopping the
Engine
To Next Page
Loading...
