To Next Page
M
Molly JohnsonAug 30, 2025
Why doesn't the bike handle clamp on my Stihl FS 410 Brush Cutter?
- VVanessa KellyAug 30, 2025
If the bike handle does not clamp, the clamps may be greasy or oily. Clean the clamps and bike handle.
Why doesn't the bike handle clamp on my Stihl FS 410 Brush Cutter?
If the bike handle does not clamp, the clamps may be greasy or oily. Clean the clamps and bike handle.
How to fix ball bearing of the clutch drum is damaged on Stihl Brush Cutter?
Replace ball bearing.
Why does the drive tube assembly on my Stihl FS 410 get very warm?
If the drive tube assembly becomes very warm, the drive shaft may not be sufficiently lubricated. Lubricate the drive shaft along its entire length, ensuring the entire length of the flexible liner is lubricated.
What to do if square profile or serration in drive train is damaged or worn on Stihl Brush Cutter?
Check drive pinion, drive shaft and clutch drum, replace if necessary.
What to do if too little or no gear lubricant in gearbox of Stihl Brush Cutter?
Add gear lubricant.
What to do if cutting attachment out of true on Stihl FS 410 Brush Cutter?
Resharpen cutting attachment, replace if necessary.
Why is the starter rope hard to pull on my Stihl FS 410 Brush Cutter?
If the starter rope is difficult to pull or rewinds very slowly, the starter mechanism may be very dirty. Thoroughly clean the complete starter mechanism.
Why does my Stihl FS 410 Brush Cutter carburetor flood and the engine stall?
If the carburetor floods and the engine stalls, the inlet needle may not be sealing due to foreign matter in the valve seat or cone. Remove and clean the inlet needle or clean the carburetor.
Why does the cutting attachment on my Stihl Brush Cutter stop under load?
If the cutting attachment stops under load at full throttle, it could be because the clutch shoes or clutch drum are badly worn. Install a new clutch or clutch drum.
Why won't the starter rope rewind on my Stihl FS 410 Brush Cutter?
If the starter rope does not rewind, heavy fouling or rust may be present on the rewind spring. Clean or replace the rewind spring.
General| Fuel Tank Capacity | 0.75 L |
|---|---|
| Shaft Type | Straight |
| Engine Power | 2.0 kW |
| Displacement | 41.6 cc |
| Overall Length | 180 cm |
