Why won't the starter rope rewind on my Stihl FS 410 Brush Cutter?
If the starter rope does not rewind, heavy fouling or rust may be present on the rewind spring. Clean or replace the rewind spring.
Why does the cutting attachment on my Stihl Brush Cutter stop under load?
If the cutting attachment stops under load at full throttle, it could be because the clutch shoes or clutch drum are badly worn. Install a new clutch or clutch drum.
Why does my Stihl FS 410 Brush Cutter carburetor flood and the engine stall?
If the carburetor floods and the engine stalls, the inlet needle may not be sealing due to foreign matter in the valve seat or cone. Remove and clean the inlet needle or clean the carburetor.
Why is the starter rope hard to pull on my Stihl FS 410 Brush Cutter?
If the starter rope is difficult to pull or rewinds very slowly, the starter mechanism may be very dirty. Thoroughly clean the complete starter mechanism.
What causes a Stihl FS 410 gearbox to run rough and stop under load?
If the gearbox runs rough and stops running under load, the drive shaft may not fully engage. Push the gearbox onto the drive tube drive pinion assembly until the drive shaft fully engages the drive pinion.
Why is my Stihl Brush Cutter making loud noises?
Loud noises could be caused by stretched tension springs. Replace all tension springs. Alternatively, the ball bearings may be damaged or worn, in which case you should replace the ball bearings on the drive side and non-drive side.
Why is the gearbox on my Stihl FS 410 becoming too hot?
If the gearbox becomes too hot, it may be due to excessive friction caused by damaged or worn ball bearings. Replace the ball bearings on the drive side and non-drive side. You may also need to add gear lubricant.
How to stop the cutting attachment rotating at idle on my Stihl FS 410 Brush Cutter?
If the cutting attachment rotates at idle, the idle speed may be too high. Readjust the idle speed screw LA. If that doesn't resolve the issue, further diagnosis may be needed.
Why is my Stihl FS 410 drive tube assembly vibrating?
If the drive tube assembly vibrates, the flexible liner may be worn, causing the drive shaft to be insufficiently supported. Replace the flexible liner.
Why doesn't the bike handle clamp on my Stihl FS 410 Brush Cutter?
If the bike handle does not clamp, the clamps may be greasy or oily. Clean the clamps and bike handle.
General| Fuel Tank Capacity | 0.75 L |
|---|---|
| Shaft Type | Straight |
| Engine Power | 2.0 kW |
| Displacement | 41.6 cc |
| Overall Length | 180 cm |
To Next Page
