HL 94
English
12
Working Techniques
Horizontal Cut (with cutter bar at an
angle)
Cutting close to the ground from a
standing position, e.g. low shrubs.
Swing the cutter bar up and down as you
move along the hedge – use both sides
of the cutting blades, do not rest the
cutter bar on the ground.
WARNING
The K version (HL 92 K) is not approved
for cutting close to the ground.
Vertical Cut (with cutter bar at an angle)
Cutting without standing directly next to
the hedge, e.g. flowerbed between
operator and hedge.
Swing the cutter bar up and down in an
arc as you move along the hedge – use
both sides of the cutting blades.
Vertical Cut (with straight cutter bar)
Extra long reach without the need for
other aids.
Swing the cutter bar up and down in an
arc as you move along the hedge – use
both sides of the cutting blades.
To Next Page
Loading...
Need help?
General
