HS 46, HS 46 C, HS 56 C
English
13
Positions and Functions of Master
Control Lever
STOP or † – Master Control lever must
be pushed in direction of STOP or † to
switch off the ignition. When released,
the Master Control lever springs back to
the normal run position F and the ignition
is switched on again.
Normal run position F – engine runs or
can fire.
Starting throttle n – this position is
used to start a warm engine. The Master
Control lever moves to the normal run
position F when the throttle trigger is
squeezed.
Choke closed l – this position is used
to start a cold engine. The Master
Control lever moves to the normal run
position F when the throttle trigger is
squeezed.
Setting the Master Control Lever
To move the Master Control lever from
the normal run position F to choke closed
l, press down the throttle trigger
lockout and squeeze the throttle trigger
at the same time and hold them in that
position – now set the Master Control
lever.
To select the starting throttle
position n, move the Master Control
lever to choke closed l first, then push
it into the starting throttle position n.
The Master Control lever moves from
the starting throttle position n or choke
closed position l to the normal run
position F when you press down the
throttle trigger lockout and blip the
throttle trigger at the same time.
To switch off the engine, move the
Master Control lever in the direction of
STOP or † – when released, the Master
Control lever springs back to the normal
run position F.
Starting the Engine
N Press the fuel pump bulb at least
five times – even if the bulb is filled
with fuel.
N Set the Master Control lever to suit
the engine temperature.
Cold engine (cold start)
N Depress the throttle trigger
lockout (1) and the throttle
trigger (2) at the same time – hold
both levers in that position.
N Move the Master Control lever (3) to
l.
N Release the throttle trigger
lockout (1), throttle trigger (2) and
Master Control lever.
Starting / Stopping the
Engine
To Next Page
Loading...
