► Fold the grip down.
Tank cap is locked.
5.5 If the tank cap cannot be
locked in the fuel tank opening
Bottom of cap is twisted in relation to top.
► Remove the cap from the fuel tank and check
it from above.
Left: Bottom of cap is twisted – inner
mark (1) in line with outer mark.
Right: Bottom of cap in correct position –
inner mark is under the grip. It is not
in line with the outer mark.
► Place the cap on the opening and rotate it
counterclockwise until it engages the filler
neck.
► Continue rotating the cap counterclockwise
(about a quarter turn) – this causes the bottom
of the cap to be turned to the correct position.
► Turn the cap clockwise and lock it in position –
see section on "Closing".
6 Rear Handle
The rear handle can be turned through 90° to the
left or right for better control and comfort in all
cutting situations.
► Let go of the throttle trigger. Do not open the
throttle.
► Disengage the lock (1).
► Turn the handle (2) to the required position
and re-engage the lock (1).
The throttle trigger may be used again when the
handle is locked in position.
Do not operate the throttle while the handle lock
is disengaged. Never disengage the lock while
you are operating the throttle.
7 Starting / Stopping the
Engine
► Observe safety precautions – see chapter on
"Safety Precautions and Working Techniques".
6 Rear Handle English
0458-448-8321-C 11