Stihl HSE 71 Instruction Manual

HSE 61, HSE 71, HSE 81
English
7
Cutting Season
Observe country-specific or municipal
rules and regulations for cutting hedges.
Do not use your power tool during other
people's rest periods.
Preparations
Use lopping shears or a chain saw to cut
out thick branches first.
Cutting Sequence
Cut the sides of the hedge first, then the
top.
If a radical cut is necessary, cut a little at
a time in several stages.
Rotating handle
Your hedge trimmer is equipped with a
rotating handle to enhance user comfort
– see chapter on “Rotating Handle”.
Disposal
Do not throw cuttings into the garbage
can – they can be composted.
Working Technique
Vertical cut
Swing the cutting blade from the bottom
upwards in an arc – lower the nose of the
blade, move along the hedge and then
swing the blade up again in an arc.
Any working position above head height
is tiring. To minimize the risk of
accidents, work in such positions for
short periods only.
Horizontal cut
Hold the cutting blade at an angle of 0°
to 10° as you swing the hedge trimmer
horizontally, using both sides of the
blade.
Swing the cutting blade in an arc
towards the outside of the hedge so that
the cuttings are swept to the ground.
If the hedge is wide, cut it in several
passes – one hand on the front switch
lever – one hand on the control handle.
Using the Unit
279BA029 KN
279BA030 KN
279BA007 KN

Stihl HSE 71 Specifications

General

Blade size	600 mm
Blade type	Double blade
Product color	Grey, Orange, Black
Vibration emission	3.8 m/s²
Engine power	600 W
Power source	Battery
AC input voltage	230 - 240 V
Power cable length	0.31 m

Weight and Dimensions

Depth	1230 mm
Weight	- g