► If the blade disk or blades are
blocked by an object: Stop the robot
mower and activate the device lock.
Only then remove the object.
► Keep children away from the robot
mower and mowing area.
► Keep animals away from the robot
mower and mowing area.
► Do not climb or sit on the robot
mower. Do not transport children,
animals or objects on the robot
mower.
■
If the behavior of the robot mower changes
during operation or feels unusual, it may no
longer be in a safe condition. This may result
in serious injury to people and damage to
property.
►
Press the STOP pushbutton and activate
the device lock. Contact a STIHL author‐
ized dealer.
■
If the blades hit a foreign object during the
mowing operation, the blades or parts of them
can be damaged or ejected at high speed.
This may result in injury to people and dam‐
age to property.
►
Remove foreign objects from the mowing
area.
► Remove broken off blades or parts of
blades from the mowing area.
■ When the STOP pushbutton is pressed, the
blade disk with the blades will continue to
rotate for a short time. People may be seri‐
ously injured.
►
Wait until the blade disk is no longer rotat‐
ing.
■ If the blades hit a hard object during the mow‐
ing operation, sparks can be produced and the
blades can be damaged. Sparks can cause
fires in a flammable environment. Persons
may be seriously or fatally injured, and prop‐
erty may be damaged.
►
Do not use in a flammable environment.
► Make sure that the blades are in a safe
condition.
DANGER
■
If the robot mower is operating near live elec‐
tric cables, the blades can come in contact
with the cables and damage them. There is a
risk of serious or fatal injury.
►
Do not operate the robot mower in the vicin‐
ity of live cables.
4.8 Charging
WARNING
■
A damaged or defective power supply may
produce an unusual smell or emit smoke dur‐
ing the charging process. This may result in
injury to people and damage to property.
►
Disconnect the mains plug from the wall
socket.
■ The power supply can overheat and cause a
fire if heat dissipation is inadequate. Persons
may be seriously or fatally injured, and prop‐
erty may be damaged.
►
Do not cover the power supply.
4.9 Connecting to the power supply
Contact with live components may occur for the
following reasons:
–
The connecting cable or the extension cord is
damaged.
–
The mains plug of the connecting cable or
extension cord is damaged.
–
The socket is not properly installed.
DANGER
■ Contact with live parts may result in electric
shock. This may result in serious or fatal injury
to the user.
►
Check that the wires and their mains plugs
are undamaged.
If the connecting cable or the extension
cord is damaged:
► Do not touch the damaged area.
► Disconnect the mains plug from the
wall socket.
►
Be sure your hands are dry before touching
the wires and their mains plugs.
► Insert mains plugs only in a properly instal‐
led and fused wall socket.
► If the wall socket is outside of a building:
Make sure that the socket is approved for
outdoor use.
►
Install the power supply with a fault current
circuit breaker (30 mA, 30 ms).
► If the connecting cable or extension cable is
connected or disconnected, always grip the
plug and do not pull on the cable.
■
A damaged or unsuitable extension cable can
result in electric shock. There is a risk of seri‐
ous or fatal injury.
►
Use an extension cable with the correct
cable cross-section, 23.5.
► Use a splash water protected extension
cable approved for outdoor use.
► Protect plug connection between the power
supply and extension cable against water.
English 4 Safety Precautions
10 0458-011-0101-A
To Next Page
Loading...
Need help?
General
