25KM 85, KM 85 R
English
: Pull the rope through the rotor and
secure it with a simple overhand
knot.
: Go to "Installing the rope rotor".
Replacing a Broken Rewind
Spring
Two types of replacement spring are
available from the factory:
– A ready-to-fit rewind spring secured
with a wire retainer.
– A rope rotor with pre-installed
rewind spring.
Installing the ready-to-fit rewind
spring
: Lubricate the spring with a few
drops of non-resinous oil – see
"Special Accessories" – do not open
the wire retainer!
: Carefully remove the parts of the old
spring from the starter cover and
rope rotor.
: Insert the new rewind spring in the
rope rotor and, at the same time,
engage the outer spring loop in the
rotor’s recess – the wire retainer
slips off in this process.
If the spring pops out and uncoils,
refit it in the counterclockwise
direction, starting outside and
working inwards.
: Go to "Installing the Rope Rotor".
Installing rope rotor with rewind
spring
: Carefully unpack the new rope rotor
with rewind spring. The spring may
pop out if not handled with care –
risk of injury.
: Lubricate the spring with a few
drops of non-resinous oil – see
"Special Accessories".
: Go to "Installing the Rope Rotor".
Installing the Rope Rotor
: Check dimension a for inner spring
anchor loop and bend it slightly if
necessary.
: Coat rope rotor bearing bore with
non-resinous oil – see "Special
Accessories".
: Slide the rotor onto the starter post –
turn it back and forth until the rewind
spring anchor loop (8) engages.
: Insert the screw (5) and tighten it
down securely.
: Go to "Tensioning the Rewind
Spring".
392BA024 KN
a
389BA029 KN
a = 2mm
(0.08 in)
8
392BA025 KN
To Next Page
Loading...
