Stihl KM 85 R - Adjusting the Throttle Cable; Throttle Cable Adjustment Procedure; Mounting the Loop Handle; Loop Handle with Barrier Bar

13KM 85, KM 85 R
English
Some machine versions are equipped
with a throttle cable adjuster in the
control handle.
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled – the
control handle must be in the normal
operating position.
: Use a suitable tool to push the slide
to the bottom of the slot (see
illustration).
: Press down the trigger interlock (1)
and squeeze the throttle trigger (2)
(full throttle) – this sets the throttle
cable correctly.
Loop Handle with Barrier Bar
: Insert square nuts (1) in the barrier
bar (2).
: Line up the holes.
Adjusting the Throttle Cable
002BA163 KN
STOP
249BA017 KN
1
2
Mounting the Loop Handle
2
002BA098 KN
1
1
All manuals and user guides at all-guides.com