0478 403 9806 B - EN
34
– 4 hoes:
two single-row hoes per drive shaft
Possible combinations
MH 560:
– 2 hoes:
one dual-row hoe per drive shaft
Possible combinations
MH 585, MH 685:
– 2 hoes:
one dual-row hoe per drive shaft
– 4 hoes:
one dual-row hoe and one single-row
hoe per drive shaft
10.4 Ideal body position when
working
The ideal body position helps to
reduce fatigue during working.
For this purpose, the machine settings
(handlebar height adjustment, brake spur
adjustment) should be selected so that a
straight posture (back) can be maintained
during the entire operating period.
Ideal body position:
– straight back
– straight legs
– lower arms bent slightly downwards
11.1 Preparatory measures
● Check engine oil level and refill tank.
(Ö 7.15)
11.2 Height adjustment of the
upper handlebar
The height of the upper handlebar
can be adjusted.
● Fold out the transport chassis. (Ö 11.4)
● Firmly grasp upper handlebar (1) at
handle (2) with one hand and hold.
● With the other hand, pull tension
lever (3) towards the rear and hold.
● Set upper handlebar (1) to the required
position.
● Press tension lever (3) forwards and
ensure that the upper handlebar is fully
engaged and fastened.
● Fold in the transport chassis if
necessary. (Ö 11.4)
11.3 Lateral adjustment of the
handlebar
The handlebar can be adjusted
laterally to three positions.
● Fold out the transport chassis. (Ö 11.4)
● Hold the upper handlebar at a handle
with one hand.
● Pull tension lever (1) upwards with the
hand.
● Move the handlebar into the required
position. Ensure that retaining lug (2) is
located above one of the three
holes (3).
● Press tension lever (1) forwards with
the hand and clamp the handlebar.
● Check the handlebar for secure
seating.
● Fold in the transport chassis if
necessary. (Ö 11.4)
11.4 Folding the transport
chassis in and out
With the aid of the transport chassis,
the tiller can be transported by pushing or
pulling.
Folding out the transport chassis –
transport position:
● Raise transport chassis (1) slightly with
one hand and hold.
● Press release lever (2).
● Fold transport chassis (1) downwards
to the stop and release the pressure on
release lever (2). The transport chassis
engages and is locked in place.
22
11. Operating the machine
Risk of injury!
Please observe the safety
instructions in the "For your safety"
section (Ö 4.) and familiarise
yourself with the controls of the
tiller. (Ö 8.)
23
24
Risk of injury!
If the transport chassis is in the
working position (folded upwards)
and the release lever is pushed, the
transport chassis can automatically
drop into the transport position.
25
To Next Page
Loading...
