ENNO
39
SVFIDASLSKTRHUSRHRBGUKETMK
0478 403 9806 B - EN
Important information on maintenance
and care of the product group
petrol tillers (STIHL MH)
STIHL assumes no liability for material or
personal damage caused by the non-
observance of information contained in the
operating instructions, in particular with
regard to safety, operation and
maintenance, or which arise through the
use of unauthorised attachment or spare
parts.
Please always observe the following
important information for the prevention of
damage or excessive wear to your STIHL
machine:
1. Wearing parts
Some parts of the STIHL machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
–V-belt
–Hoe
– Brake spur
2. Compliance with the information in
this instruction manual
The STIHL machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Improper use of the product.
– Use of fuel and lubricants not approved
by STIHL (lubricants, petrol and engine
oil, see engine instruction manual).
– Product modifications not approved by
STIHL.
– The use of attaching parts, attachments
or cutting tools not approved by STIHL.
– Use of the product for sporting or
competitive events.
– Resultant damage due to continued use
of the product with defective
components.
3. Maintenance operations
All operations listed in the section
"Maintenance" must be performed
regularly.
If these maintenance operations cannot be
carried out by the user, a specialist dealer
must be commissioned to perform them.
STIHL recommends that you have
maintenance operations and repairs
performed exclusively by a STIHL
specialist dealer.
STIHL specialist dealers regularly attend
training courses and are provided with
technical information.
If these operations are neglected, faults
may arise which are the responsibility of
the user.
These include:
– Corrosive and other resultant damage
caused by incorrect storage.
– Damage to the machine through the
use of inferior-quality spare parts.
– Damage due to untimely or inadequate
maintenance or damage due to
maintenance or repair work not
performed in the workshops of
specialist dealers.
Folding retainer (hoes):
9396 021 3785
MH 445, MH 445 R
Complete hoe set, inside left:
6241 710 0200
Complete hoe set, inside right:
6241 710 0205
Complete hoe set, outside left:
6241 710 0210
Complete hoe set, outside right:
6241 710 0215
MH 560, MH 585, MH 685
Complete hoe set, inside left:
6241 710 0220
Complete hoe set, inside right:
6241 710 0225
MH 585, MH 685
Complete hoe set, outside left:
6242 710 0210
Complete hoe set, outside right:
6242 710 0215
15. Minimising wear and
preventing damage
16. Standard spare parts
To Next Page
Loading...
