Stihl MS 150 C User Manual

MS 150 C
English
25
N Fit chain around the sprocket (1)
and over the guide bar – the cutting
edges on top of the bar must point to
the bar nose.
N Turn the tensioning screw (2)
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove.
N Refit the chain sprocket cover –
the pivot pin on the hand guard must
engage the guard on the engine
housing – and then screw the nut
onto the stud fingertight.
N Go to chapter on "Tensioning the
Saw Chain"
Retensioning during cutting work:
N Shut off the engine.
N Loosen the nut.
N Hold the bar nose up.
N Use a screwdriver to turn the
tensioning screw (1) clockwise until
the chain fits snugly against the
underside of the bar.
N While still holding the bar nose up,
tighten down the nut firmly.
N Go to "Checking Chain Tension".
A new chain has to be retensioned more
often than one that has been in use for
some time.
N Check chain tension frequently –
see chapter on "Operating
Instructions".
2011BA053 KN
1
2
2011BA054 KN
2011BA055 KN
Tensioning the Saw Chain
(side chain tensioner)
1
2011BA056 KN

Stihl MS 150 C Specifications

General

Brand	Stihl
Model	MS 150 C
Category	Chainsaw
Language	English