Stihl ms 192t User Manual

38
English / USA
MS 192 T
If engine is down on power, check the
spark arresting screen* in the muffler.
: Wait for the muffler to cool down.
: Remove the chain sprocket cover.
: Take out the screw (1).
: Remove the cover (2) and spark
arresting screen (3).
: Clean spark arresting screen if
necessary.
: If the spark arresting screen is
damaged or severely coked up,
fit a new one.
: Refit the spark arresting screen and
cover.
* see “Guide to Using this Manual”
Wrong fuel mix (too much engine oil in
the gasoline), a dirty air filter and
unfavorable running conditions (mostly
at part throttle etc.) affect the condition of
the spark plug. These factors cause
deposits to form on the insulator nose
which may result in trouble in operation.
If engine is down on power, difficult to
start or runs poorly at idling speed, first
check the spark plug.
: Remove spark plug – see "Starting /
Stopping the Engine".
: Clean dirty spark plug.
: Check electrode gap (A) and
readjust if necessary – see
"Specifications".
: Use only resistor type spark plugs
of the approved range.
Rectify problems which have caused
fouling of spark plug:
: Too much oil in fuel mix.
: Dirty air filter.
: Unfavorable running conditions,
e.g. operating at part load.
Fit a new spark plug after approx.
100 operating hours
or earlier if the electrodes are badly
eroded.
Spark Arresting Screen*
in Muffler
Checking the Spark Plug
000BA002 KN

Stihl ms 192t Specifications

General

Engine Displacement	30.1 cm³
Engine Power	1.3 kW
Guide Bar Length	30 cm
Chain Oil Capacity	0.22 l
Oilomatic Chain Gauge	1.3 mm
Oilomatic Chain Pitch	3/8"
Chain Pitch	3/8"