43MS 192 T
English / USA
: Release clutch hexagon clockwise
(left-hand thread).
: Unscrew the clutch.
: Pull the chain sprocket (4) and
needle cage (5) off the crankshaft.
: Clean the crankshaft stub and
needle cage, and lubricate with
STlHL grease (special accessory).
Installing
: Push needle cage and chain
sprocket onto the crankshaft.
: Screw the clutch onto the crankshaft
(counterclockwise).
: Tighten down the clutch firmly.
: Remove locking strip from the
cylinder. Fit the spark plug and
tighten it down firmly.
: Refit boot on the spark plug.
To Next Page
Loading...
