Stihl MS 210 Service Manual

7MS 210, MS 230, MS 250
Use the following procedure to fit a DG screw in an existing thread:
– Place the DG screw in the hole and rotate it counterclockwise until drops down slightly.
– Tighten the screw clockwise to the specified torque.
This procedure ensures that the screw engages properly in the existing thread and does not form a new thread,
which would weaken the assembly.
Note:
Power screwdriver speed setting for polymer:
– DG screws max. 500 rpm

Stihl MS 210 Specifications

General

Displacement	35.2 cm³
Bar Length	35 cm
Chain Oil Capacity	0.2 L
Chain Pitch	3/8"
Fuel Capacity	270 ml