EasyManuals Logo

Stihl MS 310 User Manual

Stihl MS 310
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
19MS 290, MS 310, MS 390
: Remove the brake spring (1) from
the bell crank (2).
VA
209RA
013
1
2
: Pry the brake band (1) out of the
engine housing.
VA
1
209RA014
: Disconnect the brake band (1)
from the bell crank (2).
VA
1
2
209RA015
Install a new brake band if there
are noticeable signs of wear
(large areas on inside diameter
and/or parts of outside diameter)
and its remaining thickness is
less than 0.6 mm.
Thickness of brake band must not
209RA194
VA
be less at any point.
: If the brake band is still
serviceable, use No. 120 emery
paper or emery cloth (grain size
approx. 120 µm) to clean and
roughen its friction surface
(inside diameter).
: Take the screw (1) together with
the bushing (2) out of the hand
guard.
VA
209RA016
: Remove the E-clip (arrow).
VA
135RA029
: Remove the strap from the bell
crank pivot pin (1).
: Slide the strap up and take it off
the hand guard pivot pin (2).
VA
135RA030
2 1
: Remove the washer (arrow).
VA
135RA031

Table of Contents

Other manuals for Stihl MS 310

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stihl MS 310 and is the answer not in the manual?

Stihl MS 310 Specifications

General IconGeneral
BrandStihl
ModelMS 310
CategoryChainsaw
LanguageEnglish

Related product manuals