MS 720
English
28
If the groove is not at least this deep:
N Replace guide bar
Otherwise the drive links will grind
against the base of the groove – the
bottoms of the cutters and the tie straps
will not lie against the bar.
If there is a noticeable loss of engine
power
N Move the choke lever (1) to the
"Choke" position.
N Release and remove the filter
cover (2) by turning it in direction of
arrow.
N Clean away loose dirt from around
the filter and inside the filter cover.
N Remove the filter.
N Knock out the filter.
N If filter is caked with dirt, wash the
parts of the filter in STIHL special
cleaner or a clean, non-flammable
solution (e.g. warm soapy water)
and then dry.
N Do not clean flocked air filters with
compressed air, a brush or a cloth.
N Always replace damaged filters.
N Reinstall the air filter.
N Fit the filter cover and secure it by
turning it in direction of arrow.
N Move the choke lever away from the
"Choke" position.
Picco 3/8“ P 5.0 mm
Rapid 3/8“; 0.325“ 6.0 mm
Rapid 0.404“ 7.0 mm
Cleaning the Air Filter
To Next Page
Loading...
