Why does the motor of my Stihl Pressure Washer constantly switch on and off?
If the motor of your Stihl Pressure Washer is constantly switching on and off, it might be due to a leaky high-pressure pump or spray attachment. In this case, have the machine checked by a servicing dealer.
How to fix a weak jet on a Stihl RE 119?
If your Stihl Pressure Washer produces a weak, ragged, or unclean jet, the nozzle might be fouled. Clean the nozzle.
Why does my Stihl High pressure cleaner pressure fluctuate or drop?
Pressure fluctuation or drop in your Stihl High pressure cleaner can be caused by several factors: * **Shortage of water:** Ensure the water tap is fully open and that you comply with the permissible suction lift, especially in suction mode. * **Dirty high-pressure nozzle:** Clean the high-pressure nozzle. * **Clogged water intake strainer:** Clean the water intake strainer in the pump inflow. * **Leaky high-pressure pump or defective valves:** Have the machine checked by a servicing dealer. * **Clogged nozzle:** Clean the nozzle.
What to do if my Stihl High pressure cleaner motor does not run when switched on but hums?
If your Stihl High pressure cleaner motor hums but doesn't run, the issue could stem from several causes: * **Low or improper mains voltage:** Check the electrical connection, including the plug, cable, and switch. * **Incorrect extension cord:** Use an extension cord with a sufficient cross-section. * **Overly long extension cord:** Connect the machine without an extension cord or use a shorter one. * **Tripped mains circuit-breaker:** Switch off the machine, actuate the spray gun until only water drips out, engage the safety catch, and then reset the circuit-breaker. * **Spray gun not actuated:** Make sure to actuate the spray gun when switching on the machine.
What to do if my Stihl High pressure cleaner has no supply of detergents?
If your Stihl High pressure cleaner is not supplying detergents, check the following: * **Empty detergent tank:** Fill the detergent tank. * **Clogged detergent intake:** Eliminate any clogs in the detergent intake.
Explains warning and notice symbols and their risks.
Precautions for electrical connections and extension cords.
Safe handling of cords and general operation rules.
Guidelines for electrical connections and extension cords.
Provides working pressure, water feed, and kickback force data.
Solutions for motor not running or spray gun not actuating.
Remedies for weak jets, pressure drops, or dirty nozzles.
Solutions for no detergent supply due to empty tank or clog.
General| Power Output | 2.1 kW |
|---|---|
| Operating Pressure | 125 bar |
| Maximum Pressure | 135 bar |
| Water Throughput | 500 L/h |
| Maximum Water Supply Temperature | 40 °C |
| Hose Length | 8 m |
| Power Consumption | 2.1 kW |
| Power Cable Length | 5 m |
| Water Flow | 500 l/h |
To Next Page
