Why does the motor of my Stihl RE 129 PLUS constantly switch on and off?
If the motor of your Stihl Pressure Washer is constantly switching on and off, it might be due to a leaky high-pressure pump or spray attachment. In this case, have the machine checked by a servicing dealer.
How to fix a weak jet on a Stihl RE 129 PLUS?
If your Stihl Pressure Washer produces a weak, ragged, or unclean jet, the nozzle might be fouled. Clean the nozzle.
Why does my Stihl High pressure cleaner pressure fluctuate or drop?
Pressure fluctuation or drop in your Stihl High pressure cleaner can be caused by several factors: * **Shortage of water:** Ensure the water tap is fully open and that you comply with the permissible suction lift, especially in suction mode. * **Dirty high-pressure nozzle:** Clean the high-pressure nozzle. * **Clogged water intake strainer:** Clean the water intake strainer in the pump inflow. * **Leaky high-pressure pump or defective valves:** Have the machine checked by a servicing dealer. * **Clogged nozzle:** Clean the nozzle.
What to do if my Stihl High pressure cleaner motor does not run when switched on but hums?
If your Stihl High pressure cleaner motor hums but doesn't run, the issue could stem from several causes: * **Low or improper mains voltage:** Check the electrical connection, including the plug, cable, and switch. * **Incorrect extension cord:** Use an extension cord with a sufficient cross-section. * **Overly long extension cord:** Connect the machine without an extension cord or use a shorter one. * **Tripped mains circuit-breaker:** Switch off the machine, actuate the spray gun until only water drips out, engage the safety catch, and then reset the circuit-breaker. * **Spray gun not actuated:** Make sure to actuate the spray gun when switching on the machine.
What to do if my Stihl High pressure cleaner has no supply of detergents?
If your Stihl High pressure cleaner is not supplying detergents, check the following: * **Empty detergent tank:** Fill the detergent tank. * **Clogged detergent intake:** Eliminate any clogs in the detergent intake.
Essential safety rules for operating the machine, including user restrictions.
Safety advice regarding high-pressure hoses and couplings to prevent accidents.
Physical condition, intended uses, and clothing recommendations for operators.
Essential checks before starting, including water supply and machine condition.
Minimizing risks associated with electrical connections and power sources.
Proper routing, use, and condition checks for power and extension cords.
Warnings during operation, including fluid hazards, cord damage, and safe footing.
Safety precautions before starting maintenance or repairs.
Steps for attaching and detaching the spray lance from the spray gun.
How to fit and remove spray nozzles into the spray lance.
Connecting and disconnecting the high-pressure hose to the unit and spray gun.
Requirements and steps for connecting to electrical power, including extension cords.
Steps to turn on the machine and enter standby mode.
How to operate the spray gun and trigger the motor for cleaning.
Diagnosing and fixing issues with motor starting or running.
Troubleshooting weak jets and pressure drops.
General| Water Flow Rate | 500 l/h |
|---|---|
| Power Consumption | 2.3 kW |
| Operating Pressure | 135 bar |
| Mains Voltage | 230 V |
| Max. Water Supply Temperature | 60 °C |
| Power Cable Length | 5 m |
| Power Source | Electric |
To Next Page
