Stihl RE 140 K - Removing; Installing Electrical Components; Switch Housing

- Remove shroud (see 5.1).
Note: Note circuit diagram; if
necessary, produce a drawing
clearly showing which wire
(note colour) is connected to the
respective terminals.
RE 140 K
•
Undo fastening screws in cover
of switch housing.
- Disconnect plug connector and
protective earth conductor.
Ensure that the serrated washer
is not lost.
- Remove switch, see 9.2.2.
- Remove cover.
•
Examine gasket (1) of switch
housing and replace if necessary.
Reassemble parts in reverse order.
RE 160 K
•
Undo fastening screws in cover
of switch housing. Ensure that
nuts are not lost.
- Remove cable lugs from switch.
- Remove switch, see 9.2.2.
- Remove cover.
•
Examine gasket (1) of switch
housing and replace if necessary.
•
Undo fastening screws of switch
housing.
•
Lift switch housing up, taking
care not to damage the wires.
•
Examine gasket (1) and replace
if necessary.
Reassemble parts in reverse order.
9.2 Removing / installing electrical components
9.2.1 Switch housing
621RA030 BL
621RA031 BL
1
621RA032 BL
1
621RA109 KN
1
621RA110 KN
24 RE 140 K, 160 K