Stihl RE 462 - Fitting, Removing High-Pressure Hose; Fitting, Removing Spray Lance

RE 362, RE 362 PLUS, RE 462, RE 462 PLUS
English
47
N Pull back and hold the coupling (1)
N Push the spray lance (2) into the
mount on the spray gun, or pull it out
to remove the spray gun,
respectively
N Release the coupling (1)
Machines without hose reel
Connecting the high-pressure hose
N Push high-pressure hose onto the
connector (1)
N Attach union nut (2) and screw it on
and tighten by hand
Disconnecting the high-pressure hose
N Unscrew the union nut (2)
N Pull high-pressure hose off of
connector (1)
Machines with hose reel
The high-pressure hose is already
connected at the factory.
Disconnecting the high-pressure hose
N Unroll the high-pressure hose (1)
N Open the hose guide (2)
N Unscrew the union nut (3).
N Pull high-pressure hose (1) off of
connector
Connecting the high-pressure hose
N Push the high-pressure hose (1)
onto the connector of the hose reel
N Attach union nut (3) and screw it on
and tighten by hand
N Push the high-pressure hose into
the hose guide (2) and close the
hose guide.
N Roll up high-pressure hose
Fitting, removing spray lance
647BA021 KN
1
2
Fitting, removing high-
pressure hose
1
9937BA009 KN
2
3
1
9937BA010 KN