EasyManua.ls Logo

Stihl RMA 443 VC - Inserting and Removing the Activation Key; Inserting the Activation Key; After Finishing Work; Transporting

Stihl RMA 443 VC
448 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0478-131-9948-A
57
English
14 After Finishing Work
Open tab (1).
Open upper part of grass catcher box (2) by handle (3)
and hold.
Hold lower handle (4) with the second hand.
Empty the grass catcher box.
Close the grass catcher box.
Attach the grass catcher box.
14.1 After Finishing Work
Switch off the mower, remove the activation key and
battery.
If the mower is wet: Allow the mower to dry.
If the battery is wet: Allow the battery to dry.
Clean the mower.
Clean the battery.
15.1 Transporting the Lawn Mower
Switch the lawn mower off.
The blade must not be turning.
Pull out the activation key and remove the battery.
Pushing the lawn mower
Push the lawn mower forwards slowly and in a controlled
manner.
Carrying the lawn mower
Wear work gloves made from resistant material.
If the lawn mower is being carried by two people:
One person holds the lawn mower by transport
handle (1) using both hands and another person holds
handlebar (2) using both hands.
The lawn mower must be lifted and carried by two
people.
If the lawn mower is being carried by one person:
Fold down the handlebar.
Hold the lawn mower with one hand on transport
handle (1) and the other hand on handle (2).
Lift and carry the lawn mower.
Transporting the lawn mower in a vehicle
Secure the lawn mower upright so that the lawn mower
does not tip over and cannot move.
15.2 Transporting the Battery
Switch off the mower and remove the battery.
Make sure the battery is in a safe condition.
Observe the following points when packing the battery:
The packaging must be non-conductive.
Make sure the battery cannot shift inside the packaging.
14 After Finishing Work
15 Transporting

Table of Contents

Related product manuals