ENES
13
PTEL           
0478 192 9809 A - EN
Always drive at a reasonable speed. 
Use the machine with great care when 
working near slopes, terraces, ditches and 
embankments. In particular, ensure that 
you maintain sufficient distance to such 
danger areas.
Particular care must be taken at points of 
poor visibility, bushes, trees and other 
obstacles, behind which persons, 
especially children, or animals may be 
hidden.
Bring the ride-on mower to a standstill 
immediately and stop the mowing blade if 
someone moves into the area to be mown.
Always monitor the area in front of the 
vehicle. Beware of obstacles, in order to 
be able to evade them in time.
Before reversing, always check the area 
behind the ride-on mower and, if present, 
disengage the attachment. Never mow in 
reverse, if it is not absolutely necessary. 
When mowing in reverse, take particular 
care and before beginning to mow, 
thoroughly check the entire area behind 
the ride-on mower.
When working together in a group, always 
inform the others in advance of what you 
intend to do. Maintain a safety distance!
The vehicle speed must be reduced before 
each change of direction, so that the user 
retains control of the machine at all times 
and also that the ride-on mower cannot tip 
over.
When operating near to roads and when 
crossing roads, other road users must be 
taken into account.
Take particular care when mowing near 
roads, cycle paths and footpaths. Objects 
which are thrown up by the mower can 
cause severe injury and damage.
Only empty the grass catcher box from the 
driver's seat.
Before emptying the grass catcher box, 
always disengage the mowing blades and 
wait until they have come to a standstill.
When operating the ride-on mower with 
attachments, always follow the 
instructions and safety regulations 
supplied with the attachments.
Switch off the drive, stop the engine and 
wait until the mowing blades have come to 
a complete standstill, engage the parking 
brake and remove the ignition key:
– when abandoning or when transporting 
the machine.
– before remedying blockages, including 
those in the discharge chute.
– before checking, cleaning or working on 
the ride-on mower.
– if the mowing blades have hit an 
obstacle.
Inspect the machine and the cutting tool 
for damage and have any necessary 
repairs performed before re-starting. 
Additionally check the installation 
position of the mowing blades on the 
models RT 5112 Z, RT 6112 C, 
RT 6112 ZL, RT 6127 ZL – the mowing 
deck must not be engaged if the angle 
of the blades relative to each other is 
not as specified in the section "Mowing 
blade maintenance". (Ö 15.13)
– if the machine begins to vibrate 
excessively. It must be checked 
immediately.
Stop the engine and wait until the mowing 
blades have come to a complete standstill:
– Before filling with fuel.
– Before removing the grass catcher box.
– Before opening the engine hood.
Driving with cruise control:
Activating cruise control in the wet or 
under adverse ground conditions as well 
as when pulling loads increases the 
accident risk.
When cruise control is switched off, the 
ride-on mower brakes abruptly.
Cruise control is an aid that provides 
assistance when driving. The 
responsibility for the driving speed and for 
timely braking always lies with the user.
Cruise control does not react to obstacles 
or to altered ground conditions. If an 
obstacle cannot be avoided at the set 
driving speed, cruise control must be 
switched off.
Due to the increased risk of accident, 
cruise control must not be used:
– In situations which do not permit driving 
at constant speed (e.g. adverse ground 
conditions due to wet conditions or on 
slopes).
– On slippery surfaces. The wheels may 
lose their grip and the vehicle can skid.
– If visibility is poor (e.g. due to fog, heavy 
rain or at night).
Working on slopes:
Slopes are one of the major causes of 
accidents in which control over the ride-on 
mower is lost causing it to tip over, which 
can result in severe or even fatal injuries.
There is no "safe" slope! Driving on grassy 
slopes requires special concentration.
For safety reasons, the machine must not 
be used on slopes with an inclination of 
more than 10° (17.6 %). Risk of injury!