Stihl SR 450 - Page 55

54 SR 430, SR 450
: Rotate the leg clockwise and
engage it on the lever (arrow).
Version with throttle limiter
: Slip the torsion spring (1) over
the pivot pin so that its long
leg (2) points in the direction of
the handle housing.
– Engage the leg (2) against the
guide (arrow).
: Fit the interlock lever (1) into
position and engage the torsion
spring (arrow).
0002RA162 TG
0002RA163 TG
1
2
0002RA164 TG
1
: Rotate the interlock lever (1) until
the lug (2) is behind the edge of
the housing (arrow).
: Push home the interlock lever (1)
until it is properly seated.
: Position the cam (1) so that the
lug (2) points towards the throttle
trigger.
: Push the cam (1) past the throttle
trigger and onto the setting
lever's pivot pin (short arrow).
Make sure the contact spring is not
bent.
0002RA165 TG
1
2
0002RA166 TG
1
2
Version with throttle lock
: Turn the cover (1) clockwise until
it is between the edge of the
housing and stop (arrow).
: Push home the cover (1) until it is
properly seated.
: Position the cam (1) so that the
lug (2) points towards the throttle
trigger.
: Locate the cam (1) in the throttle
trigger (arrow) and push it onto
the setting lever's pivot pin (3).
Make sure the contact spring is not
bent.
0002RA498 TG
1
0002RA501 TG
1
2
3