Stihl SR 450 - Page 87

86 SR 430, SR 450
: Fit the gasket (1) into the
groove (arrow).
: On the underside, engage the
cutouts in the gasket over the
lugs (arrows).
– Hold the rotary shutter with the
toothed pivot pin (1)
pointing in the direction of
the anti-vibration spring (2).
: Fit the rotary shutter (3) in
the hole (arrow).
0002RA337 TG
1
0002RA338 TG
0002RA339 TG
1
2
3
: Push the pivot pin (1) into the
hole (arrow).
: Fit the lever (1) into the hole so
that it engages the teeth.
– Push the lever (1) fully home.
– Check operation
– the rotary shutter must open
and close when the lever is
turned.
: Insert and tighten down the
screw (1) firmly.
0002RA340 TG
1
0002RA341 TG
1
0002RA363 TG
1
– Install the cable, b 10.4
– Make sure that the
gasket (1) is properly
seated.
– Position the metering unit (1) with
AV springs in the seats and push
it into place.
: Push the clamping strap (2) into
place.
: Insert the screws (arrows) and
tighten them down firmly.
0002RA138 TG
1
0002RA479 TG
1
2