Stihl SR 450 - Page 95

94 SR 430, SR 450
: Fit the hose (1) in the
guide (arrow).
Version with pressure pump
: Push the hose (1) onto the stub.
– Tighten down the hose clamp (2)
firmly.
SR 430 versions with and without
pressure pump
: Push the blower housing (1) with
the anti-vibration springs into the
lower spring seats (arrow) until
they snap into position.
0002RA379 TG
1
0002RA362 TG
1 2
0002RA387 TG
1
: Insert and tighten down the
screws (1) on the underside of
the machine.
Version without pressure pump
: Pull off the hose (1) and molded
hose (2).
: Squeeze the tabs (arrow) of the
hose clamp together until they
engage.
Version with pressure pump
: Fit the hoses (1) and molded
hose (2).
0002RA374 TG
1 1
0002RA388 TG
2
1
0002RA389 TG
2
1
1
3 3
: Fit and tighten down the hose
clamps (3).
SR 430 versions with and without
pressure pump
: Push the blower housing (1) with
the upper anti-vibration springs
into the spring seats (arrow) until
they snap into position.
Versions with long back padding
: Fit and tighten down the
screws (1) firmly.
0002RA390 TG
1
0002RA490 TG
1 1