21TS 400
English / USA
: Cut deeper into the parting cut with
uniform back-and-forth movements,
starting at the top and moving out
towards the sides. Advance the
cutting wheel along the guiding
groove at full cutting depth. Always
reposition the cutting wheel afresh,
taking care not to wedge it if the
cutting direction has to be corrected
slightly. If necessary, leave small
ridges of uncut material to hold the
severed part in position. These
ridges can subsequently be broken
through.
Economic benefit is improved and
premature wear can be avoided by
choosing and using the correct
composite resin cutting wheel. The
short name (e.g. “asphalt“, “concrete“)
– on the label and
– on the packaging (table with
recommended uses)
can help to ensure the correct choice.
STIHL composite resin cutting wheels
cannot be used to cut railway tracks.
Economic benefit is improved and
premature wear can be avoided by
choosing and using the correct diamond
cutting wheel. The short name (see
following explanation)
– on the label and
– on the packaging (table with
recommended uses)
can help to ensure the correct choice.
STIHL composite resin
cutting wheels
STIHL diamond cutting
wheels
To Next Page
Loading...
