29TS 400
English / USA
: Use the combination wrench to
loosen and unscrew the hexagon
bolt (2).
: Remove the front thrust washer (3)
from the arbor together with the
abrasive wheel to be replaced.
: Fit the abrasive wheel (4).
Note the arrows indicating the
sense of rotation on diamond
abrasive wheels.
: Fit the front thrust washer (3).
The catches of the front thrust
washer must engage in the arbor
grooves.
: Fit the hex head screw and tighten
it down firmly with the combination
wrench (or to about 30 Nm if you
use a torque wrench)
: Draw the locking pin out of the
V-belt guard.
Two diamond wheels of the same
type can also be used together if a
wider cut is required (e.g. for laying
induction loops in carriageways).
It is essential to ensure that the
segments are positioned exactly
side by side in such a case.
However, two composite abrasive
wheels must never be used
simultaneously, for they can break
and cause injuries as they wear
down unevenly.
338BA007
338BA008
To Next Page
Loading...
