Stihl TS 400 - Fitting and Replacing Abrasive Wheels

28
English / USA
TS 400
Choosing an abrasive wheel
STIHL abrasive wheels can be used to
cut the following materials:
Composite abrasive wheels
(depending on type) can be used for
– Asphalt
– Concrete
–Stone
– Ductile cast pipes
–Steel
Diamond abrasive wheels
(depending on type) can be used for
–Asphalt
– Concrete
– Stone (hard rock)
– Abrasive concrete
– Green concrete
– Clay bricks
– Clay pipes
Diamond abrasive wheels cannot be
used to cut metal.
The engine must be switched off when
fitting or replacing an abrasive wheel –
slide control / stop switch to "0" or c
In order to block the arbor,
: slide the locking pin (1) through the
bore in the V-belt guard (turn the
arbor a short distance with the
combination wrench if necessary)
until the locking pin engages in one
of the bores behind the guard.
002BA139 KN
002BA140 KN
Fitting / replacing an
abrasive wheel
3
38BA006
1