31TS 400
English / USA
Before fueling, clean the filler cap and
the area around it to ensure that no dirt
falls into the tank.
Always thoroughly shake the mixture in
the canister before fueling your
machine.
In order to reduce the risk of burns
or other personal injury from
escaping gas vapor and fumes,
remove the fuel filler cap carefully
so as to allow any pressure build-up
in the tank to release slowly.
After fueling, tighten fuel cap as
securely as possible by hand.
Change the fuel pick up body every
year.
: Before storing your machine for a
long period, drain and clean the fuel
tank and run engine until carburetor
is dry.
: Note the safety instructions.
Refer to the chapter headed "Safety
precautions".
: Press the throttle trigger
interlock (1) and throttle trigger (2)
at the same time
: Hold both triggers down
: Move the control lever (3) to START
and hold it in this position
: Then release the throttle trigger,
control lever and throttle trigger
interlock in succession =
starting throttle position
Fueling
338BA009
338BA010
Starting / stopping
the engine
3
2
1
338BA011
3
START
338BA012 KN
To Next Page
Loading...
