32
English / USA
TS 400
: Set the choke lever (4):
to g if the engine is cold
to e if the engine is warm
(even if the engine has already run
but is still cold)
to f if the engine is hot
(latched position for warm start)
: Press the button of the
decompression valve (5).
This button must be pressed again
before each fresh attempt to start
the engine.
: Place the cut-off machine on the
ground, keep a good balance and
ensure that the abrasive wheel
cannot touch any objects or the
ground. There must not be anyone
within the swivel range of the cut-off
machine.
: Press the cut-off machine firmly
against the ground, holding with the
left hand, thumb wrapped round the
handle.
: Place your right foot through the
rear handle.
: With your right hand, slowly pull out
the starter handle as far as the stop,
then pull it through quickly and
strongly. Do not pull the rope out
completely.
The rope may break!
Do not let the starter handle snap
back: guide it back into place so that
the starter rope is wound up
correctly.
If the engine is new, pull the starter rope
through several times to ensure that
sufficient fuel is delivered.
4
338BA013 KN
Choke
5
START
338BA014 KN
38BA015
38BA016
To Next Page
Loading...
