Stihl TS 700 - Fitting and Replacing Abrasive Wheels; Wheel Mounting and Replacement Steps

31TS 700, TS 800
English / USA
The engine must be switched off when
fitting or replacing an abrasive wheel –
set slide control / stop switch to "0" c.
: In order to block the shaft, slide the
locking pin (1) through the bore in
the V-belt guard (turn the shaft a
short distance with the combination
wrench if necessary) until the
locking pin engages in one of the
bores behind the guard.
: Use the combination wrench to
loosen and remove the hexagon
bolt (2).
: Remove the front thrust washer
(flange) (3) from the shaft together
with the abrasive wheel to be
replaced.
: Fit the new abrasive wheel (4).
Note the arrows indicating the
direction of rotation on diamond
abrasive wheels!
They must match the arrow on the
machine.
: Fit the front thrust washer
(flange) (3). The catches of the
front thrust washer must engage in
the shaft grooves!
: Screw in the hexagon bolt and
tighten it with the combination
wrench (tighten down with approx.
30 Nm (22 lbs ft) when using a
torque wrench).
: Draw the locking pin out of the
V-belt guard.
Fitting / replacing an
abrasive wheel