30
English / USA
TS 700, TS 800
The abrasive wheels are subjected to
extremely high loads, especially when
cutting free-hand.
The abrasive wheels developed by
STIHL in cooperation with leading wheel
manufacturers are of very high quality
and precisely matched to the application
in question, as well as to the engine
power of the respective cut-off
machines.
They are of consistently outstanding
quality, with high axial and radial runout.
Transport and storage
– The abrasive wheels must not be
exposed to direct sunlight or other
sources of heat during transport and
storage
– Avoid knocks and bumps
– Spare abrasive wheels must be
stored in a dry place at constant
temperature, stacked one on top of
the other on a flat surface, in their
original packaging.
– Abrasive wheels must not be stored
near corrosive liquids
– Composite abrasive wheels must
be protected against frost
Choosing an abrasive wheel
STIHL abrasive wheels can be used to
cut the following materials:
Composite abrasive wheels
(depending on type) can be used for
–Asphalt
–Concrete
–Stone
– Ductile cast pipes
–Steel
Diamond abrasive wheels
(depending on type) can be used for
– Asphalt
–Concrete
– Stone (hard rock)
– Abrasive concrete
– Green concrete
– Clay bricks
–Clay pipes
Diamond abrasive wheels cannot be
used to cut metal.
Abrasive wheels
002BA139 KN
002BA140 KN
To Next Page
Loading...
