TS 800
English
18
Removing the adjusting lever
N Remove screws (1)
N Remove the adjusting lever (2)
N Pull out sealing plug (3)
Slackening the V-belt
N To relax the poly V-belt, loosen the
nuts (1) – do not unscrew the
nuts (1) from the studs
N Turn the tensioning nut (2)
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
N Unscrew nuts (1) from the studs –
nuts (1) are fastened to the belt
guard so that they are secured
against loss
Removing the V-belt guard
N Remove the V-belt guard (1) and
remove the poly V-belt from the
front pulley
N Remove the "support with
guard" (2)
Preparing the "support with guard" for
outboard mounting
N Unscrew stop pin (1)
N Turn the guard so that it is in the
position shown (see picture)
N Screw in and tighten the stop pin (1)
N Move the adjusting lever (2) to
position A
N Screw in and tighten the screws (3)
N Press in sealing plug (4)
To Next Page
Loading...
