TS 800
English
19
Mounting "support with guard" – guard
on the outboard side
N Fit the "support with guard" (1) on
the outboard side – at the same
time, guide the poly V-belt over the
belt pulley
NOTICE
The belt action must run smoothly.
N Position the V-belt guard (2)
N Align studs (3) in bearing with
nuts (4) in the V-belt guard
N Screw nuts (4) onto studs (3) – do
not tighten them yet
N Connect water connection
Checking the adjustment range of the
guard
N Rotate the guard forwards and
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
“Tensioning the ribbed V-belt”.
Inboard mounting
N Disassemble the abrasive wheel
(see “Fitting / replacing an abrasive
wheel”)
N Remove water attachment
N Remove the adjusting lever
N Slacken the V-belt
N Remove the V-belt guard
N Remove "support with guard"
Preparing the "support with guard" for
inboard mounting
N Unscrew stop pin (1)
N Turn the guard so that it is in the
position shown (see picture)
N Screw in and tighten the stop pin (1)
N Install the adjusting lever
N Mount "support with guard" – guard
on the inboard side
N Install the V-belt guard
N Connect water connection
To Next Page
Loading...
