4 Operation
Replacing and transporting the bat
tery
Changing to a different battery type
The authorised service centre can convert the
truck to a different battery type and capacity.
Note the following points:
• The new battery capacity and new battery
type must be set in the display-operating
unit.
If this is not done, the actua
l battery dis-
charge status cannot be dete
rmined. The
battery charge level is not d
isplayed cor-
rectly.
In the worst case, the battery may be
damaged by a deep discharge.
• When changing to TENSOR
®
batteries, the
maximum speed of the truck must be limited
to 17 km/h for technical reasons.
– Contact the authorised se
rvice centre in this
situation.
– Only use lithium-ion batteries that have
been approved by STILL with this truck.
6327_600-010
1
Opening/closing the battery cover
Opening the battery cover
CAUTION
The outside mirror (1) is in the movement range of
the battery cover. When opening the battery cover,
a collision can cause components to be damaged.
– Fold outside mirror forwards.
– Ensure that there is sufficient lateral distance (at
least 100 mm) from the battery cover.
334
171533 EN - 02/2019 - 19
To Next Page
Loading...
