STMicroelectronics STEVAL-IHP005V1 - Firmware Data Types

Firmware description UM1619
32/56 DocID024383 Rev 1
6.5 Firmware data types
The data type found in the application.h module, are listed below:
/* USER FRAME STRUCTURE */
typedef struct
{
APP_source_t source;
APP_ftype_t type;
bool broadcast;
u16 group;
u32 address;
u8 len;
u8 data[USER_PAYLOAD_SIZE]; /* MAX PAYLOAD SIZE: 100 bytes */
APP_ERROR_t error;
}APP_userdata_t;
/* PERIPHERAL SOURCE TYPE */
typedef enum
{
SOURCE_COMM,
SOURCE_USB,
SOURCE_SPI,
SOURCE_PLM
}APP_source_t;
/* APPLICATION FRAME TYPE */
typedef enum
{
APP_DATA_FRAME = 0x00,
APP_SERVICE_FRAME = 0x01,
APP_PING_FRAME = 0x02,
APP_ERROR_FRAME = 0x03,
APP_PROGRAMMING_FRAME = 0x04,
APP_ACK_FRAME = 0x05
/* <!> MAX ALLOWED TYPE RANGE: FROM 0x00 TO 0x7F */
}APP_ftype_t;
/* APPLICATION ERRORS */
typedef enum
{
APP_ERROR_NONE = 0x00, // No error
APP_ERROR_GENERIC = 0x01, // Generic communication error
APP_ERROR_COMM_TIMEOUT = 0x02, // Communication timeout error
APP_ERROR_SERVICE_GRP_UNKNOWN = 0x03, // Service group unknown error
APP_ERROR_SERVICE_CMD_ERROR = 0x04, // Service command error
APP_ERROR_COMMUNICATION = 0x05, // Communication error
APP_ERROR_ISOLATED_NODE = 0x06, // Node unreachable error
APP_ERROR_HARDWARE = 0x07, // Hardware error
APP_ERROR_WRONG_PROG_COMMAND = 0x08, // Wrong programming command error
APP_ERROR_WRONG_PROG_GROUP = 0x09, // Wrong programming group error
APP_ERROR_DEVICE_BLANK = 0x0a, // Device blank
APP_ERROR_RTC_ERROR = 0x0b, // Error setting the system time
APP_ERROR_WATCHDOG_DISABLED = 0x0c, // Hardware reset impossible
APP_ERROR_NODE_INIT_FAILED = 0x0d, // Node initialization failure
APP_ERROR_RTC_DISABLED = 0x0e // Internal RTC disabled
}APP_ERROR_t;
/* USER COMMUNICATION FLAGS */
typedef enum
{
USER_DATA_TRANSMISSION_START,
USER_DATA_TRANSMISSION_END,
USER_DATA_ARRIVED,
USER_DATA_COMMUNICATION_ERROR,